How Do I Set Up My Dual Head Motion Security Flood Light Model Number: S10DFL/850/MOT/WH

I need Setup instructions for the Dual Head Motion Security Flood Light.

This setup guide walks you through unboxing, wiring, and configuring your flood light for the first time. It includes everything from mounting to adjusting the motion sensor and timer settings. With just a few tools and the included hardware, you’ll be ready to brighten up your property.

Key Areas Covered:

• Model Number: S10DFL/850/MOT/WH

• Unboxing & What’s Included

• Powering the Device

• Common Setup Issues

• Set Up Steps

• FAQs

• Usage & Tips

Unboxing & What’s Included:

Check your box for the following:

• Dual-Head Security Flood Light (1 Pc)

• Mounting Plate (1 Pc)

• Mounting Gasket (1 Pc)

• Mounting Bar (1 Pc)

• Spacers (2 Pcs)

• J-Box Screws (2 Pcs)

• Mounting Plate Screws (2 Pcs)

• Decorative Washers (2 Pcs)

• Decorative Nuts (2 Pcs)

• Mounting Bar Screw (1 Pc)

Powering the Device:

• Connect to a 120V AC, 60Hz circuit.

• Requires hardwiring into a junction box (external or flush).

• Always turn off power at the breaker before installation.

Common Setup Issues:

• Light doesn’t turn on: Check breaker and ensure wires are secure.

• Sensor triggers during the day: Ensure Dusk-to-Dawn mode is not active.

• Light cycles on/off repeatedly: May be detecting its own reflection. Reposition the fixture.

Set Up Steps:

1. Turn off power at the breaker.

2. Install mounting bar to junction box using screws.

3. Feed wires through the gasket and mounting plate.

4. Secure mounting plate and gasket with provided screw.

5. Connect wires: Black to L, White to N, Green to Ground.

6. Secure the fixture body to the mounting plate with washers and decorative nuts.

7. Apply silicone sealant around the base to protect against moisture.

8. Restore power at the breaker.

9. Adjust the motion sensor head and set timer/sensitivity knobs as needed.

FAQs:

• Q: Do I need a special junction box?
  A: No, a standard flush or external J-box works.

• Q: Can I install this myself?
  A: If you’re comfortable with electrical work, yes. Otherwise, hire a licensed electrician.

• Q: Does it work right away?
  A: The PIR sensor has a 30-second warm-up period after power is restored.

Usage & Tips:

• Test the light in “Test Mode” before using normal timer settings.

• For maximum motion detection, aim the sensor within 45° of horizontal.

• Avoid placing near moving trees, roads, or water to reduce false triggers.