How to Install and Use the OneSync Landscape Low Voltage Converter Box

How do I install and use the OneSync Landscape Low Voltage Converter Box?

If you have an existing hardwired landscape lighting system and want to connect it to the OneSync ecosystem, the OneSync Landscape Low Voltage Converter Box is the perfect solution. Here's how to install and use it:

Installation

Step 1: Start by turning off the power at the breaker.
Step 2: Remove the existing low voltage wire that is connected to your transformer's output terminals.
Step 3: Connect the black wire from the OneSync controller to the 12 or 15 volt terminal of the transformer.
Step 4: Connect the white wire to the COM terminal.
Step 5: Open the waterproof seal below the button and loosen the screws.
Step 6: Remove the rubber gasket at the bottom of the box and thread your existing low voltage wires through the gasket and into the output terminals.
Step 7: Tighten the screws to secure the wires and replace the rubber seals.
Step 8: Mount your converter box with the provided screws. If mounting in anything besides wood, use the included anchors.
Step 9: Restore your power and ensure your transformer is always on, removing any previous power settings.

Usage & Tips

• To pair your converter box to the remote, simply turn it on by pressing and holding down the button until the indicator light starts rapidly blinking.
• Press and hold the desired group until the indicator light stops blinking.
• To pair your converter box to the Wi-Fi bridge, put the box in pairing mode.
• Select the group number in your Feit app and tap "add fixture."
  Tips: The OneSync low voltage controller is easy to install and use, and it expands the functionality of your landscape lights. You can now control your landscape lights with your remote or app. You can turn your lights on and off or set a timer for them.
  
  

Note: The OneSync Landscape products, which are designed for outdoor use, are not compatible with our indoor OneSync Undercabinet Lights.