Using the OneSync Landscape Remote to Control Outdoor OneSync Landscape Lighting

How Do I Use the OneSync Landscape Remote to Control My Lights?

Controlling all your OneSync lights in your ecosystem is simple with the OneSync Landscape remote. This remote gives you control by allowing you to group your lights, alter their brightness, whiteness, and color, as well as create a timer. Follow the steps below to use the OneSync Landscape remote with your existing OneSync products.

Note: Any previously installed OneSync lights will be pre-paired in group 1 on the remote.

Watch this video or follow the steps below to set up your Wi-Fi Smart Bridge.

Installation

Step 1: Install the batteries in the back of the remote by removing the backplate.

Step 2: You can pair new lights to the remote in groups, or individually at any time. To pair a light or lights, simply hold down the button or buttons on your OneSync lights until the lights start blinking slowly. Please note that pairing mode will time out after 3 minutes.

Step 3: Once the lights are in pairing mode, press and hold the desired group number to pair your lights to that group. The lights will flash once to indicate that they are paired to that group number. Repeat this process to group your OneSync lights to your liking.

Step 4: To unpair a light or lights, put them in pairing mode and press the group number that the lights are paired to. Then, hold the power button until the lights flash once. Another way would be to hold down the button on a landscape light for 10 full seconds. This will remove it from all previously paired groups. Essentially, performing a hard reset of that unit.

Usage & Tips

• Attempting to pair your lights with the OneSync Landscape Wi-Fi Remote, or other Landscape lights? We advise carrying out the pairing procedure at night or turning the light fixture over so the solar panels are flat to the ground and out of direct sunlight.
• You can now conveniently adjust the brightness of your lights, shade of white, color, or set a timer all from your remote. Please note that adjusting colors or shades of white can only be done in the evening when your lights come on.
• For added convenience, you may hang your remote by mounting the backplate with the accompanying double-sided tape to put on any spotless flat surface, or with the screws and/or anchors included for fixing in wood or drywall.
• Someone else like a neighbor controlling your lights? Remove that particular light from Group 1 and assign it another group.

Note: The OneSync Landscape products, which are designed for outdoor use, are not compatible with our indoor OneSync Undercabinet Lights.