How Do I Set Up My Vista 1x2 Flat Panel LED Skylight?

Where can I find set up guide information for the Vista 1x2 Flat Panel LED Skylight?

Ready to brighten up your space with a clean, modern skylight look? This guide walks you through everything you need to know to set up your Vista 1x2 Flat Panel LED Skylight. From unboxing to wiring, we’ve got you covered with clear, actionable steps. Before you begin, make sure you have basic electrical knowledge or hire a licensed electrician, as this fixture is hardwired.

Key Areas Covered:

Model Number: FP1X2/SKY/5CCT/WH

• Unboxing & What’s Included
• Powering the Device
• Common Setup Issues
• Set up Steps
• FAQs
• Usage & Tips

Unboxing & What’s Included:

Before installation, verify you have all components:

• • 1x Flat Panel LED Skylight Fixture
  • Wire Connectors (pre-installed)
  • Mounting Hardware
  • Installation Manual
  • Quick Start Guide

Powering the Device - This fixture is not battery-operated. It must be hardwired into your ceiling using standard 120V power. Always turn off the breaker before beginning any electrical work.

Common Setup Issues - Fixture doesn’t turn on. Check wiring and confirm power supply is live.

• MultiMode switch not responding – Ensure the switch used is a standard on/off toggle, not a dimmer or smart switch.
• Sky or side light not illuminating – Recheck wire connections and confirm color temp selection jumper is properly set.

Set up Steps:

1. Turn Off Power at the Circuit Breaker
   Safety first. Ensure no electricity is flowing before installation begins.
2. Unpack the Fixture and Verify All Components
   Remove packaging and confirm that all listed parts are included.
3. Choose Your Desired Color Temperature
   Use the built-in jumper switch to select from 3000K, 3500K, 4000K, 5000K, or 6500K for the side light. This must be set before mounting.
4. Prepare Ceiling and Mounting Location
   Ensure a junction box is present in the ceiling. Use a stud finder and level to mark mounting holes if needed.
5. Wire the Fixture to Power Source
   Connect black to black (hot), white to white (neutral), and green to ground. Use wire nuts to secure connections. Tuck wires neatly into the junction box.
6. Secure the Fixture to the Ceiling
   Use the provided screws and mounting brackets to attach the fixture firmly to the ceiling.
7. Test the MultiMode Switch Functionality
   Restore power at the breaker. Toggle the wall switch to cycle through:
   • Skylight + White Light
   • White Light Only
   • Skylight Only
8. Optional: Connect to a Compatible Dimmer
   For full dimming functionality, pair the unit with an LED-compatible wall dimmer.

FAQs:

• Can I install this without a junction box?
  No, a ceiling-mounted junction box is required for hardwiring.
• Does it work with smart home systems?
  No, this model is not smart-enabled.
• Can I change the white light color later?
  No, the color temperature must be set during installation.

Usage & Tips:

• If your wall switch is a dimmer, make sure it's LED-compatible to avoid flickering.
• Mount the panel in rooms where natural light is limited for a skylight effect.
• Label your breaker box for easy future servicing.
• Use the switch toggling trick (ON-OFF-ON) to access different light modes.