Feit Electric Door Lock with Camera Doorbell Setup Details for DOORVIDEOLOCKAGBK & DOORVIDEOLOCKAGNK

How Do I Set Up My Feit Electric Door Lock with Camera Doorbell?

This guide walks you through installing and configuring your Feit Electric Door Lock with Camera Doorbell. The process includes mounting the hardware, inserting the battery, and pairing the lock with the Feit Electric mobile app.

Key Areas Covered:

Model Number: DOORVIDEOLOCKAGBK & DOORVIDEOLOCKAGNK

• Unboxing & What’s Included

Included hardware:

• Front panel
• Rear panel
• Latch mechanism
• Strike plate
• Strike box
• NFC key cards (2)
• Backup keys (2)
• Mounting screws
• Rechargeable battery pack

Tools Required

• Phillips screwdriver

Powering the Device:

The lock uses a rechargeable battery pack installed inside the rear panel.

A USB-C port is also available for charging or emergency power.

Common Setup Issues:

• Incorrect latch size selection
• Battery inserted incorrectly
• Lock not in pairing mode
• Bluetooth disabled on mobile device

Setup Steps:

1. Prepare the Door

• Verify door thickness and bore hole size meet installation requirements.
• Measure the backset (2-3/8" or 2-3/4").

2. Install the Strike Plate and Strike Box

• Insert the strike box into the door frame.
• Secure the strike plate using the provided screws.

3. Adjust the Latch Size

Select the correct latch length:

• 60 mm (2-3/8")
• 70 mm (2-3/4")

Make sure the latch slot is centered.

4. Install the Lock Latch

• Insert the latch into the door.
• Secure it with the provided screws.

Ensure the latch bevel faces the correct direction.

5. Install the Front Panel

• Feed the connector cable through the door.
• Position the front panel flush with the exterior side of the door.

6. Install the Rear Panel

• Connect the cable to the rear unit.
• Secure the rear panel using the mounting screws.

7. Insert the Battery Pack

• Insert the rechargeable battery into the rear compartment.
• Close the battery cover.

The lock will automatically calibrate when powered on.

8. Download the Feit Electric App

• Search Feit Electric in the App Store or Google Play.
• Install the application.

9. Pair the Lock With the App

1. Open the Feit Electric app.
2. Tap the “+” Add Device icon.
3. Press and hold the reset button for 3–5 seconds to enter pairing mode.
4. Select the lock from the device list.
5. Follow the prompts to finish setup.

Once paired, the lock will automatically calibrate for door opening direction.

FAQs:

How long should I charge the battery before installation?
Charge the battery fully before installing the lock.

What if the lock doesn’t appear in the app?

• Make sure Bluetooth is enabled.
• Confirm the lock is in pairing mode.

Can I install the lock on both left- and right-hand doors?
Yes. The lock supports left-hand and right-hand opening directions.

Usage & Tips:

Helpful Setup Advice

• Install the lock while the door is open during calibration.
• Ensure the base plate is vertical with the door edge.
• Always test unlocking methods before closing the door fully.
• Register at least two unlocking methods (fingerprint + code).